![]() Once you complete your install, make sure you post heat your wrap. When installing the side panel, start by installing the large center piece first. It’s recommended to begin the installation with smaller pieces such as the headlight pod to familiarize yourself with the material.ħ. More info on each specific method can be found on the SCS Unlimited website.Ħ. For the textured plastic including side panels, we prefer to use a dry application method. For areas including the tunnel and the large smooth plastic on the hood SCS recommends a wet application method. SCS Unlimited installers utilize both wet and dry application methods. Remove any excess glue with Rapid Remover, and clean snowmobile thoroughly with isopropyl alcohol.ĥ. Pay attention to the angle you are pulling them off, for example pulling outward and down typically leaves less glue behind. Take special care not to overheat, which could cause damage to the sled’s plastic. ![]() Remove intake screens on the headlight pod to avoid melting screen.Ĥ. We recommend Rapid Tac application products, heat gun, squeegee, and X-Acto knife. Familiarize yourself with the provided install key for your respective Ski-Doo chassis type.Ģ. Upon receiving your sled wrap, remove from shipping tube and lay flat in a clean, room temperature location allowing the graphics to return to their original flat position. ![]() Some of us probably shouldn’t be left alone with a butter knife! Regardless of your experience installing a sled wrap, or where your dexterity registers, we’ve got tips from the fine folks over at SCS Unlimited to help make installation of your new snowmobile wrap easy.ġ. Now, some people are just gifted with a steady hand and a sharp eye. For a first-timer, wraps can look complex and intimidating to install. That’s why Ski-Doo teamed up with SCS Unlimited to offer you unlimited creativity when it comes to personalizing your ride with a wrap. Your sled is an extension of your personality.
0 Comments
Leave a Reply. |